Floor Hardener

Product Details:

Renafix Floor Top is a non-metallic floor hardener, which contains specially graded non metallic hard wearing natural aggregates. It is applied as a dry shake over freshly floated concrete to provide a durable, non-slip monolithic floor.

Features:
Long service life:
High abrasion and impact resistance

Extended service life:
Better abrasion resistance than plain concrete

Non- rusting:
Suitable for wet environments

Non-slip:
Improved safety for personnel and forklifts in wet environments.

Dense surface:
Resists oil and grease penetration

Coloured surface:
Can create aesthetically pleasing environment

Easy application at time of placing concrete:
Floor available for full service once concrete is cured.

Application Methodology:
It is recommended that the floor be marked off into bays of known area. Sufficient material should be laid out to meet the required spread rates. Application of Rena Top Hardener can begin when the base concrete has stiffened to the point when light foot traffic leaves an imprint of about 3mm. Any bleed water should by now have evaporated. Renafix Floor Top is applied in two stages.

• The first application is made using 50% to 70% of the total material. Rena Top Hardener is evenly broadcast onto the concrete surface. When the material becomes uniformly dark by the absorption of moisture from the concrete this first application can be floated. Wooden floats or, on large areas, the power trowel with disc may be used. It is important, however, that the surface is not over worked.
• Immediately after floating, the remaining Rena Top Hardener is sprinkled evenly over the surface. Again moisture is absorbed and the surface can be floated in the same way as before. Final finishing of the floor using a power trowel can be carried out when the floor has stiffened sufficiently so that damage will not be caused.